APPLICATION PROCEDURES
- The surface to be painted must be clean from dirt, dust, oil, rust, old paint which still stick and other contaminants
- Sanding the surface with sandpaper grit 800 – 1000
- For better adhesion on the metal, use Durogloss epoxy primer
- To close the pores of wood, use Propan PCR 1000 Epoxy Primer Products or Propan Wood Filler. And then sand with sandpaper grit 800 – 1000
- Stir well DUROGLOSS NC approximately (± 5 minutes) before add thinner
- If you want more matte appearance, add Propan Matting Solution MS-21, according mixing direction before add thinner
- Add Thinner Propan Super or Thinner Durogloss with comparison 1: 1 ratio or until it reaches a viscosity 11-12 sec NK2, and stir well. When using MS-21, decrease amount of thinner appropriate with amount of additional of MS-21.
- Spray evenly with a stable air pressure, approximately (± 1.5 – 2 bar)
- For more maximum protection and gloss look, Durogloss NC can be applied with PCR PU Clear Gloss series after 2 hours
- Apply this paint at places where have ventilation or good air circulation
| DUROGLOSS | |
| Type | Nitrocellulose |
| Color | Different Colors |
| Theoretical Coverage | 11 – 14 m2/liter – 1 layer (Depend on application) |
| Drying Time | Surface Dry : 10 – 20 Minutes Hard Dry : 1 – 2 Hours (Depend on temperature and humidity) |
| Solid Content (%) | 36 – 45 |
| Viscositas (Din cup 6) | 60 -100 |
| Gloss | 90 – 95 |
| Daya tutup | 72 – 100 |
| Thinning Ratio | 1 : 1.5 by volume |
| Thinner | Propan Thinner ND Super |
| Application Method | Airless Spray |
